| Model description |
Some good modelling experience is required.
Every airliner is a custom built model. The 301-E's design is a combination of traditional construction techniques and unique EDFmodel assembly techniques.
Wingspan 1400mm (4.6 Ft), length 1195mm (4 Ft).
Weight AUW approximately 1620g (3.5 lb).
Control surfaces All moving tail plane, inboard fowler flaps, ailerons, rudder and steerable nose wheel.
Features Retractable undercarriage & lighting system.
Hardware EDFmodel fans, brushless motors, speed controllers, retractable undercarriage, lighting system & servos.
EDFmodel views the 301 RC airliner as an experimental model design. EDFmodel does not mass produce models rather each airliner built is a unique custom built airliner. The 301 is deemed a "work-in-progress" model. The
model is always in a state of design and re-design as the collective experience of building the airliners accumulates. With each new model there is always some design improvement and even hardware changes. Thus 301 model design is always in a beta
testing phase.
|
| Model finish |
Airliner decals can be selected from the photo gallery pages. These are existing graphic designs. A standard white configuration is also possible.
Can I have a model built up in my own choice of airliner colours?
Yes - an additional cost may be required depending upon the decal complexity.
Some colours & designs can be difficult. For example the painting of a fuselage using two-tone colours. This type of work becomes the domain of artists and EDFmodel may not be
able to accept such an order
|
| Model assembly |
To complete the final assembly of the model and a successful flight will require the input of a moderately experienced modeller.
The 301-E airliner is shipped in several sub-assemblies requiring final assembly upon arrival. To allow for the shipping the wings are supplied in two parts. They require gluing together. Installation of the receiver and battery
(not supplied with the kit) is required.
The final assembly should take less than a day. Instructions are provided.
|
| Retractable wheels |
DSR-30 retractable undercarriage set with controller. Nose doors open and close.
|
| Flaps |
Inboard Fowler type flaps -as the flap continues to extend its angle progressively increases. Requirement here for the transmitter set to have a dail for flap extension.
|
| Lights |
2 x Red fuselage strobes lights
2 x Wing landing lights
2 x Wing tip Green/Red lights
|
Hardware
supplied |
2 x 301 EDFmodel fans
2 x 4900 kv brushless motors
2 x 30 Amp controllers
4 X Hitec HS-45HB servos
1 x Hitec HS-56HB servos
2 x Hitec HD-35 servos
1 x DSR-30 retractable undercarriage set with controller
1 x Castle 10 Amp BEC
1 x lights and controller
|
| Power setup |
The power setup of the 301-E is excellent with a high thrust-to-weight ratio producing short take-offs.
On a 3s battery the engine & fan combination will sink at full throttle 60 Amps, producing 620 watts. This translates into approximately 1100g (2.4 lbs) of static thrust. A 3300 mAH battery will provide a flight time upwards of 7 minutes if the
model is flown in a slow airliner like fashion.
One recommended battery is the Thunder Power G6 Pro Lite LiPo 3300Mah 3S 25C. It is 19mm in height weighing 243g (8.5 oz).
|
| Rudder |
|
Additional
hardware
required |
Additional items required (not supplied with the model) include
- a 2600 - 3300 mAh 3s 20-30C battery. The maximum battery size that will fit the model is 21 x 48 x 150 mm (0.82 x 1.8 x 5.9)"
- battery charger & balancer
- transmitter & receiver
If you are an experienced modeller, there is a good chance you may already own this equipment. If not, your local hobby store can supply and service these items. Unfortunately, as the shipping of batteries is
prohibited, EDFmodel cannot supply these items.
|
| Transportation |
A fully assembled 301-E fits into a family sized station wagon.
|
| Shipping |
Shipping to the US and most other countries is efficient by Express Courier International (ECI). This service provides priority handling, internet
tracking, insurance and a signature on delivery. It offers reliable delivery within 3 to 7 business days. Two boxes of sizes 102L x 36W x 34H cm are shipped.
Taxes & duties. There is no duty on model aircraft (to a limit) payable when shipped to the USA (Harmonised Tariff Code is 95032000 -toys, reduced scale models for recreation). For other countries, taxes and duties
will vary according to customs and tax regulations. Payment of any duties and taxes will be the responsibility of the customer. The maximum allowable duty-free value will vary from country to country. Consult your customs department.
|
| Model design |
EDFmodel views the 301 RC airliner as an experimental model design. EDFmodel does not mass produce models rather each airliner built is a unique custom built airliner. EDFmodel differs
from most other model manufacturers in that all models supplied are deemed "work-in-progress" models. These are designed and built by Ian Monty (EDFmodel).
The model is always in a state of design and re-design as the collective experience of building the airliners accumulates. With each new model there is always some design improvement or update and even hardware changes. Thus the 301 model design is always in
a beta testing phase.
EDFmodel takes every reasonable step to ensure the airworthiness of built up models. However it is impractical for EDFmodel to completely test every single design change that is made. As such EDFmodel can not in
guarantee the performance of your completed model, other than to indicate other pilots flying the 301 shown as photos and video on this site.
It is the user's responsibility to inspect each component for airworthiness and the entire model airliner system as a whole for airworthiness before
flying.
Accepting these conditions is a condition of purchase. Please read the full terms & conditions before proceeding with an order.
|
| Model costs |
Each model is a unique custom built airliner. EDFmodel does not mass produce models.
Hand building each model takes time and planning. There is often a six week lead time.
Orders are placed in advance to reserve time on the production line. To confirm an order a fifty percent
deposit is required.
Costs are displayed in US dollars and are exclusive of shipping. A typical world wide shipping & insurance cost is $US 290.
Payment is in US dollars with a bank transfer. Payment plans may be accepted upon request.
|
| Ordering |
Placing an order
For general enquiries, please use contact us
Airliners are assembled in the same order as the requests are received. EDFmodel.com reserves the right to alter delivery dates if unforeseen issues arise. In this case you will be informed
of changes.
Order cancellation. Every model is custom built. Once time has been reserved on the production line EDFmodel.com will not accept the cancellation of the order. No refunds will be
provided for any deposits. Any deposits paid represent the cost of the production schedule time. All responsibility is the care of the customer. EDFmodel.com will not negotiate for the re-sale of any partially completed model on a customers behalf.
Any model whose final balance payment has not been made after 45 days notice will be deemed abandoned and will be deposed of to recover costs. EDFmodel.com will not enter into any negotiations on these cancellation terms.
Limited Warranty & Liability. EDFmodel offers s limited warranty and acceptance of this warranty is a condition of purchase. See the full terms & conditions.The 301-E is a "work-in-progress" model and EDFmodel.com reserves the right to alter
design specifications without notice.
Radio controlled model aircraft use. The user shall determine the suitability of the model aircraft or
product for their intended use and shall assume all risk and liability in connection with the product. The user is required to read all instruction manuals and follow the manufacturers guidelines. EDFmodel.com cannot accept responsibility for injury and/or loss
during the use of any radio-controlled model. Great care should be taken when using radio controlled products. If you have questions or concerns seek the assistance of a more experienced modeller who is a fully paid up member of an aeronautical model
association.
|
